Malossi RS24/10-R Racing Rear Shock for Kymco AK550
SPECIFICATIONS:
Wheelbase adjustment device. Turn to modify the height of the rear axle – 2mm + 8mm with respect to the original.
Extension adjustment to change the brake during re-opening of the shock absorber after being compressed .
Adjustment of the spring pre-load to increase or decrease the ??initial?? load of the shock absorber and consequently to determine the greater or lesser initial rigidity of the system, i.e. the effort required to start the
suspension by adjusting the agility, manueverability and stability of the vehicle.
Compression adjustment to control the brake when closing the shock absorber and varying of the behaviour of this in relation to the unevenness of the ground. It is possible to use a more rigid but more stable sporting set-up or
a gentler more comfortable touring configuration. The regulation acts at low shock absorbing speeds, that is during operation of the shock absorber on bends or when traversing slightly accentuated holes. At high speeds, instead,
when, for example, pronounced potholes are present, perhaps in a completely straight line, a brake consists of a 20mm sintered piston with a specially calibrated valve pack.
COMPATIBILITY:
Kymco – AK550
The RS24/10-R is equipped with two nitrogen tanks for rod compensation. This system is used to completely modify the load curves depending on the pressure of each chamber, that is the handling modes during compression and extension,
and guarantees greater compactness to the shock absorber with respect to the system with a single external tank, reduced friction and greater dispersion of the heat produced by functioning of the system.
**