for PIAGGIO 50ccm 2T AC/ LC
secondary
grouted
17,7mm
Product description
We know how it goes: you’ve done your best to tune up your motor to bring it up to an appreciable performance level – then find that your speed isn’t going any where cause the original transmission only helps with acceleration rather than bringing the power performance up where you really want it. Always at the limit, your motor works it’s heart out for you, but….. which in turn means stress, wear and tear for crankcase, bearings and pistons.Alonger transmission gives you the chance to get the same speed – but at a lower rpm’s for a healthier motor. Give yourself an extra margin andmore performance without stressing out on inclines. Your acelleration lost can be made up with a variator readjustment. The rolls a little lighter, your clutch a little harder.The sport transmissions fromMALOSSI andPOLINI are mainly straight geared, making the interlock area smaller and so reducing friction. Lower friction in your transmission means less heat and you’re finally getting that badly needed power to your rear wheels.In case you drive aPIAGGIO/GILERA motor, please take note of the following information about your gears:1.Up till 1996
, PIAGGIO usedtoothed bears with 18mm
.2.From 1996 to 1998
. PIAGGIO reduced the diameter of the intermediate shaft from 18mm to17.7mm
. To make sure you get the right part, please measure shaft diameter before ordering.3.Since 1998/99 PIAGGIO has been using a new larger cog wheel on the main shaft. A new pinion with asmooth inner surface has replaced the previous used pinion which had a toothed inner surface.Before you order a transmissioin for these motors, make sure you measure exactly and check out if toothed or pressed smooth.
OEM numbers (for comparisons):
67 9966 (MALOSSI)
EAN Number:
42602771803772